ASTM A1117-23

1.1This practice defines the minimum requirements for the application of Thermal Spray Aluminum (TSA) coatings to carbon steel pipe for the purpose of preventing atmospheric corrosion or corrosion under insulation. This practice is intended to be effective for TSA coatings applied at pipe manufacturing facilities or at on-site assembly locations.

1.2This practice is for the application of TSA to the external surfaces of piping to prevent atmospheric corrosion of insulated and non-insulated surfaces.

1.3This practice includes requirements for surface preparation, materials, application and quality control of TSA applied to carbon steel piping at the pipe manufacturing facility or at an on-site-assembly location.

1.4This practice is expressed in both inch-pound and SI units. However, unless the order specifies the use of metric values, inch-pound units shall be used.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.