ASTM A484/A484M-23

Standard Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings

ASTM International , 03/01/2023

Publisher: ASTM

File Format: PDF

$41.00$83.00

Description

Standard By:ASTM International , 03/01/2023

Published:03/01/2023

Pages:14

File Size:1 file , 370 KB

Language:English

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1This specification2 covers general requirements that shall apply to wrought stainless steel bars, shapes, forgings, and billets or other semi-finished material (except wire) for forging, under each of the following speciﬁcations issued by ASTM: Specifications A276/A276M, A314, A458, A477, A479/A479M, A564/A564M, A565/A565M, A582/A582M, A638/A638M, A705/A705M, and A831/A831M.

1.2In the case of conflict between a requirement of a product specification and a requirement of this specification, the product specification shall prevail. In the case of conflict between a requirement of the product specification or a requirement of this specification and a more stringent requirement of the purchase order, the purchase order shall prevail. The purchase order requirements shall not take precedence if they, in any way, violate the requirements of the product specification or this specification; for example, by waiving a test requirement or by making a test requirement less stringent.

1.3The requirements for introduction of new materials in specifications referencing this specification are given in Annex A1.

1.4General requirements for flat-rolled stainless steel products other than bar are covered in Specification A480/A480M.

1.5General requirements for wire products in coils are covered in Specification A555/A555M.

1.6The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.7Unless the order specifies an "M" designation, the material shall be furnished to inch-pound units.

1.8This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.