ASTM C478/C478M-22

Standard Specification for Circular Precast Reinforced Concrete Manhole Sections

ASTM International , 09/01/2022

Publisher: ASTM

File Format: PDF

$27.00$54.00

Description

Standard By:ASTM International , 09/01/2022

Published:09/01/2022

Pages:10

File Size:1 file , 140 KB

Language:English

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1This specification covers the manufacture and purchase requirements of products used for the assembly and construction of circular vertical precast reinforced concrete manholes and structures used in sewer, drainage, and water works.

1.2Part I, Sections 1 - 11, of this specification presents general requirements and requirements that are common to each precast concrete product covered by this specification.

1.3Part II of this specification presents specific requirements for each manhole product in the following sections:

Product Section Grade Rings 12 Flat Slab Tops 13 Risers and Conical Tops 14 Base Sections 15 Steps and Ladders 16

Note 1:Future products will be included in Part II in a future revision of this specification.

1.4The values stated in either inch pound or SI units are to be regarded separately as standard. The SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

Note 2:This specification is a manufacturing and purchase specification only and does not include requirements for backfill, or the relationship between field load conditions and the strength requirements of the manhole products and appurtenances. Experience has shown, however, that the successful performance of this product depends upon the proper selection of the product strength, type of foundation and backfill, and care in the field installation of the manhole products and connecting pipes. The owner of the project for which these products are specified herein is cautioned to require inspection at the construction site.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.