ASTM D5800-18a

1.1This test method covers four procedures for determining the evaporation loss of lubricating oils (particularly engine oils). Procedure A uses the Noack evaporative tester equipment; Procedure B uses the automated non-Woods metal Noack evaporative apparatus; Procedure C uses Selby-Noack volatility test equipment, and Procedure D uses the Noack S2 test equipment. The test method relates to one set of operating conditions but may be readily adapted to other conditions when required.

1.2Noack results determined using Procedures A and C provide equivalent results and Procedures B and D provide equivalent results. However, A/C compared to B/D show consistent differences. Procedure A/C give slightly lower results versus Procedure B/D on formulated engine oils, while Procedure A/C give higher results versus Procedure B/D on basestocks.

1.3The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.