ASTM D6392-23

Standard Test Method for Determining the Integrity of Nonreinforced Geomembrane Seams Produced Using Thermo-Fusion Methods

ASTM International , 11/01/2023

Publisher: ASTM

File Format: PDF

$31.00$63.00

Description

Standard By:ASTM International , 11/01/2023

Published:11/01/2023

Pages:5

File Size:1 file , 440 KB

Language:English

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1This test method describes destructive quality control and quality assurance tests used to determine the integrity of geomembrane seams produced by thermo-fusion methods. This test method presents the procedures used for determining the quality of nonbituminous bonded seams subjected to both peel and shear tests. These test procedures are intended for nonreinforced geomembranes only.

1.2The types of thermal field seaming techniques used to construct geomembrane seams include the following:

1.2.1Hot Air-This technique introduces high-temperature air or gas between two geomembrane surfaces to facilitate melting. Pressure is applied to the top or bottom geomembrane, forcing together the two surfaces to form a continuous bond.

1.2.2Hot Wedge (or Knife)-This technique melts the two geomembrane surfaces to be seamed by running a hot metal wedge between them. Pressure is applied to the top or bottom geomembrane, or both, to form a continuous bond. Some seams of this kind are made with dual bond tracks separated by a nonbonded gap. These seams are sometimes referred to as dual hot wedge seams or double-track seams.

1.2.3Extrusion-This technique encompasses extruding molten resin between two geomembranes or at the edge of two overlapped geomembranes to effect a continuous bond.

1.3The types of materials covered by this test method include the following:

1.3.1Very low-density polyethylene (VLDPE).

1.3.2Linear low-density polyethylene (LLDPE).

1.3.3Very flexible polyethylene (VFPE).

1.3.4Linear medium-density polyethylene (LMDPE).

1.3.5High-density polyethylene (HDPE).

1.3.6Polyvinyl chloride (PVC).

1.3.7Flexible polypropylene (fPP).

Note 1:The polyethylene identifiers presented in 1.3.1 - 1.3.5 describe the types of materials typically tested using this test method. These are industry-accepted trade descriptions and are not technical material classifications based upon material density.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D6392-23

Standard Test Method for Determining the Integrity of Nonreinforced Geomembrane Seams Produced Using Thermo-Fusion Methods

ASTM D6392-23 History

ASTM D6392-23

ASTM D6392-12(2018)

ASTM D6392-12

More ASTM Standards PDF

BS 07/30168004 DC

BS 07/30165293 DC

BS 07/30155372 DC

BS CP 2010-2:1970