ASTM D7800/D7800M-23

1.1This test method is primarily for the determination of elemental sulfur in natural gas pipelines, but it may be applied to other gaseous fuel pipelines and applications provided the user has validated its suitability for use. The detection range for elemental sulfur, reported as sulfur, is 0.0018 mg/L to 30 mg/L. The results may also be reported in units of mg/kg or ppm.

1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.