ASTM F1414-19(2023)

Standard Test Method for Measurement of Cut Resistance to Chainsaw in Lower Body (Legs) Protective Clothing

ASTM International , 11/01/2023

Publisher: ASTM

File Format: PDF

$34.00$69.00

Description

Standard By:ASTM International , 11/01/2023

Published:11/01/2023

Pages:15

File Size:1 file , 2.1 MB

Language:English

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1This test method measures cut resistance of garments and devices worn to protect the lower body (legs) when operating a chainsaw.

1.2This test method may be used to test for compliance to minimum performance requirements in established safety standards.

1.2.1By agreement between the purchaser and the supplier, or as required by established safety standards, it will be decided if this test method will be used to determine one or both of the following: (1) chain speed 50 (CS50), and (2) success/failure (jamming/chain stop or no cut in less than 1.5 s) at specified chain speed.

1.3This test method may be used to determine levels of protection for areas of coverage as stipulated in established safety standards.

1.4The values stated in SI units are to be regarded as standard.

Note 1:The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.