ASTM F3109-22

Standard Practice for Verification of Multi-Axis Force Measuring Platforms

ASTM International , 09/01/2022

Publisher: ASTM

File Format: PDF

$34.00$68.00

Description

Standard By:ASTM International , 09/01/2022

Published:09/01/2022

Pages:9

File Size:1 file , 420 KB

Language:English

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1This standard recommends practices for performance verification of multi-axis force platforms commonly used for measuring ground reaction forces during gait, balance, and other activities.

1.1.1This standard provides a method to quantify the relationship between applied input force and force platform output signals across the manufacturer''s defined spatial working surface and specified force operating range.

1.1.2This standard provides definitions of the critical parameters necessary to quantify the behavior of multi-axis force measuring platforms and the methods to measure the parameters.

1.1.3This standard presents methods for the quantification of spatially distributed errors and absolute measuring performance of the force platform at discrete spatial intervals and discrete force levels on the working surface of the platform.

1.1.4This standard further defines certain important derived parameters, notably COP (center of pressure) and methods to quantify and report the measuring performance of such derived parameters at spatial intervals and force levels across the working range of the force platform.

1.1.5This standard defines the requirements for a report suitable to characterize the force platform''s performance and provide traceable documentation to be distributed by the manufacturer or calibration facility to the users of such platforms.

1.1.6Dynamic characteristics and applications where the force platform is incorporated in other equipment, such as instrumented treadmills and stairs, are beyond the scope of this standard.

1.1.7This standard is written for purposes of multi-axis force platform verification. However, the methods and procedures are applicable to calibration of force platforms by manufacturers.

1.2The values stated in SI units are to be regarded as the standard. Other metric and inch-pound values are regarded as equivalent when required.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.