ASTM F594-22

Standard Specification for Stainless Steel Nuts

ASTM International , 11/01/2022

Publisher: ASTM

File Format: PDF

$122.00$245.69

Description

Standard By:ASTM International , 11/01/2022

Published:11/01/2022

Pages:8

Language:English

Note:This product is unavailable in Russia, Belarus

1.1This specification covers the requirements for stainless steel nuts 0.25 to 1.50 in., inclusive, in nominal diameter in a number of alloys in common use and intended for service applications requiring general corrosion resistance.

1.2Seven groups of stainless steel alloys are covered, including ten austenitic, two ferritic, four martensitic, and one precipitation hardening.

Group Alloys^A Condition^B 1 304, 305, 304L 384, 18-9LW, 302HQ^C (CW) cold worked^D 2 316, 316L (CW) cold worked^D 3 321, 347 (CW) cold worked^D 4 430^E (CW) cold worked^D 5 410^F (H) hardened and tempered 6 431 (H) hardened and tempered 7 630 (AH) aged hardened

1.3Supplementary requirements of an optional nature are provided, applicable only when agreed upon by the manufacturer and the purchaser at the time of the inquiry and order.

1.4Suitable bolts, hex cap screws, and studs for use with nuts included in this specification are covered by Specification F593. Unless otherwise specified, all bolts, hex cap screws, and studs used with these nuts shall conform to the requirements of Specification F593 and shall be of the same alloy group.

1.5The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.