IEEE 1826-2012

This standard identifies open system interfaces for high power electronics equipment used in zonal electrical distribution systems rated above 100 kW. Interfaces are grouped into key and non-key interfaces and are based on technological maturity, accepted practices, and allowances for future technology insertions. This standard defines how openness of system should be verified and validated through rigorous assessment mechanisms, interface control management, and proactive conformance testing to enable plug-and-play operability independently of the components origin. It also formulates specific interface requirements for open zonal electrical distribution systems on ships and platforms. The purpose of this document is to provide a uniform standard for high power electronics open system interfaces in zonal electrical distribution systems rated above 100 kW. The stated specifications and requirements are universally applied to maintain total power system performance and efficiency under changing mission and loads conditions. They will be sufficient for most installations, including ships and platforms. This standard complements IEEE Std 1662. New IEEE Standard - Superseded. Open system interfaces for high power electronics equipment used in zonal electrical distribution systems rated above 100 kW are identified in this standard. The required power, monitoring, information exchange, control, and protection interfaces are based on technological maturity, accepted practices, and allowances for future technology insertions. Also, rigorous assessment mechanisms, interface control management, and proactive conformance testing that shall be used to verify and validate open systems to enable plug-and-play operability independently of the components' origin are defined. Airports, hospitals, major data processing centers (especially those using uninterruptible power supply), broadcast systems, and maritime vessels and platforms are applications covered by this standard. Existing terrestrial utility power systems that do not yet contain the electronic power interfaces and high-speed communication networks that are essential to use this standard shall be upgraded by its application.